Hummer 2006 H3 Manuel d'utilisateur télécharger pdf (Page 318)

100

101

To adjust the vertical aim, do the following:

1. Open the hood. See Hood Release on page 5-11

for more information.

2. Find the aim dot on the lens of the headlamp.

3. Measure the distance from the ground to the aim

dot on the headlamp. Record the distance.

4. At the wall or other ﬂat surface, measure from the

ground upward the recorded distance from Step 2

and mark it.

5. Draw or tape a horizontal line the width of the

vehicle at the wall or other ﬂat surface where it

was marked it Step 4.

Notice: Do not cover a headlamp to improve beam

cut-off when aiming. Covering a headlamp may

cause excessive heat build-up which may cause

damage to the headlamp.

6. Turn on the headlamps and place a piece of

cardboard or equivalent in front of the headlamp

not being aimed. This should allow only the beam

of light from the headlamp being aimed to be

seen on the ﬂat surface.

7. Locate the vertical headlamp aiming screws, which

are under the hood near each headlamp assembly.

The adjustment screw can be turned with an

E8 Torx

socket or T15 Torx

screwdriver.

Passenger’s Side Shown

5-46

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 419 420

Commentaires sur ces manuels

Pas de commentaire

Hummer 2006 H3 Manuel d'utilisateur Page 318

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Hummer 2006 H3